Isdn Trunk Data Assignment - NEC NEAX 2400 IPX Programming Manual

2. ISDN TRUNK DATA ASSIGNMENT

STEP 1: ASYD - Assign the following indexes.
STEP 2: ARTD - Assign the route data for both Bch and Dch.
Note 1: INT (CDN65):
For "SUB ADDRESS - ADDRESSING", assign "0". (Refer to
Note 2:
6.)
For "DID ADDRESSING", refer to
SYSl Index 91: Single PLO b7 b6
Dual PLOs
1
SYSl Index 186: CCIS/ISDN in service b6 b6
SYSl Index 187: always 00 (hex)
SYSl Index 220: ISDN is in service
Data for Bch/ Data for Dch
2 - ONSG : 2/2 4 - INSG : 2/2
7 - L/T : 1/1 8 - RLP : 2/2
28 - ANS : 1/1 30 - PAD : 4/7
34 - GUARD : 1/0 45 - A/D : 1/0
65 - INT : 66 - DC :
Note 1
The other data should be "0" (default data).
1 N-ISDN2
2 Australia
3 INS 1500
4 ITU (CCITT), ETSI
5 AT&T (#4/#5 ESS)
6 INS 64
7 NT DMS 100 / DMS 250
8 Not used
9 TTC Q931a protocol Tie Line (Japan)
10 Q-SIG. (ETS 300 172)/IS-11572
BASIC DATA ASSIGNMENT FOR ISDN
b5 b4
0 1 0
b7 b6 b5 b4
1 1 1
1 0 (When b6=1, ISDN service is invalid.)
For BRI Type of Interface
5 - TF : 3/0
10 - SMDR : 1/0
31 - OGRL : 1/0
50 - DPLY : 1/0
Note 2
"DID Addressing" in Chapter
NDA-24305
1
6 - TCL : 1/1
15 - LSG : 12/13
32 - ICRL : 1/0
63 - LYER1 : 0
"SUB Address - Addressing"
6.
in Chapter
CHAPTER 3
Page 9
Revision 1.0