Pri Station (H11) - NEC NEAX 2400 IPX Programming Manual

4. PRI STATION (H11)

Note: PA-ILCG is necessary for H11 (2B+D).
STEP 1: Assign the numbering (LCR) data to access to H11 terminal.
STEP 2: ARTD - Assign the same route data as the data for
Give the separate RT NO. to Bch of PRT and ILC respectively.
Note:
STEP 3: ATRK - Assign the trunk data for Bch referring to the example below. Note that the trunk data for
H11
to Bch and Dch route.
CDN64 (NET)= 1
CDN65 (INT)= 5 (AT & T)/7 (NT)
CDN66 (DC)= 15
CDN96 (H1)= 1
CDN118 (BOB)= 1
Dch is assigned after Step 6: ACIC1 command assignment.
I 24
L P
C R
G T
PIM0
Group 03 05 07
No.
02 04 06
Bch:RT10
Dch:RT12
2B+D
ILC
Note
24B
PRT
Bch:RT11
Chapter
ILCG (2B+D) B1 =000030 RT10 TK1
PRT (24B)
NDA-24305
SUPPLEMENTARY SERVICE
3, and arrange the following specific data
LENS
B2 =000031 RT10 TK2
Dch =000020 RT12 TK1
B1 =000050 RT11 TK1
B24 =000077 RT11 TK24
CHAPTER 6
Page 167
Revision 1.0