NEC NEAX 2400 IPX Programming Manual page 170

TANDEM SWITCHING OF TIE TRUNKS-2/4-WIRE-PRI
STEP 6: ARRC - Assign to the system trunk-to-trunk connection. Use Alternative Route Index (ARI) D for
STEP 7: APAD - Assign any Pad data that may be required for desired quality of service. (Optional, see TIE
In the network including CCIS No.7, assign data CDN98 (CI)=1 (of the ARTD command) to all speech
Note:
routes of CCIS No.7 network.
Refer to [T-44] TRANSFER MESSAGE (TRM).
CHAPTER 5
Page 152
Revision 1.0
Direct Connection. Three possible Restrictions (RES) may be assigned; data "0",
Connection is Restricted; data "1", Connection is Allowed; or data "2", Toll Restriction is
required. For TANDEM SWITCHING OF TIE TRUNKS-2/4 WIRE, TOLL
RESTRICTION is not required.
LINE CONNECTION WITH PAD CONTROL [T-5]).
NDA-24305