Pri Station (H0) - NEC NEAX 2400 IPX Programming Manual

3. PRI STATION (H0)

STEP 1: Assign the numbering (LCR) data to access to H0 terminal.
STEP 2: ARTD - Assign the same route data as the data for
STEP 3: ATRK - Assign the trunk data for Bch. Note that the data setting for Dch is performed after STEP
6: ACIC1 command assignment. (Refer to
STEP 4: ADPC - Assign PC (Point Code) to Bch route and Dch route. (Refer to the following example)
H0
to Bch and Dch route.
CDN64 (NET)= 1
CDN65 (INT)= 5 (AT&T)/7 (NT)
CDN66 (DC)= 15
CDN118(BOB)= 1
RT=15 (Bch) PC=11
RT=16 (Dch) PC=11
23B+D
PRT
Bch:RT15
Dch:RT16
Chapter
Chapter 3.)
NDA-24305
SUPPLEMENTARY SERVICE
3, and arrange the following specific data
CHAPTER 6
Page 165
Revision 1.0