NEC NEAX 2400 IPX Programming Manual page 83

3. Programming
STEP 1: ASYD - System Data 1, Index 5, bit 0: Are the access codes for CALL FORWARDING-BUSY
STEP 2: ANPD - Reserve a number level for feature access and cancel. Assign Connection Index, CI = N;
STEP 3: ASPA - Assign an access code to CALL FORWARDING-DON'T ANSWER entry, SID = 12, and
STEP 4: ASFC - Assign the stations to receive CALL FORWARDING-DON'T ANSWER a Service
STEP 5: AKYD - For D
STEP 6: ATNR - Allow tenant-to-tenant connection for Inter- and Intra-tenant connections. Assign Tenant
STEP 7: ACFO - For tenant-wide CALL FORWARDING-DON'T ANSWER assign CF = 2 for a destination
Note
STEP 8: ACFS - CALL FORWARDING-DON'T ANSWER can also be assigned via the ACFS command.
Note: Step 7 is necessary for Call Forwarding on a system basis only.
Index 69, bit 1: Send short tone when a call forwarded via C.F.-ALL
Index 139:
Index 141:
Index 145:
Normal. Assign NND in accordance with a predetermined numbering plan.
to CALL FORWARDING-DON'T ANSWER cancel, SID = 13. Assign Connection Status
Index (CI) for Normal service.
Feature Class that allows SFI = 8.
term
sets, CALL FORWARDING-DON'T ANSWER may be assigned to a
programmable line/feature key. Assign KYI = 2 and FKY = 22.
Restriction Index (TRI) = 1. For this service feature to be set by the Attendant Console,
assign Inter- and Intra-Tenant connection via the Attendant Console, TRI = 3. Also assign
TRI = 0, station-to-station calling.
(CFI) of either the Attendant Console or a station.
CALL FORWARDING-DON'T ANSWER-PRI
LINE [C-2] and
ANSWER the same or separate? 0/1: Same/Separate.
Calls service is answered. 0/1: Not Required/Required
bit 2: Send short tone when a recalled C.F.- All Calls call is
answered. 0/1: Not Required/Required
Assign the No Answer timer for station-to-station, DID
and TIE Line calls. Default data is 30sec.
Assign the No Answer timer for incoming calls via the
Attendant Console. It will then be forwarded to the next
station according to SYS1, Index 145 timer. Default data
is 10sec.
Assign the time an incoming call via the Attendant
Console will ring at the CALL FORWARD-DON'T
ANSWER station before recalling to the Attendant
Console. Default data is 32sec.
NDA-24305
CALL FORWARDING-DON'T
CHAPTER 5
Revision 1.0
Page 65