Multiple Call Forwarding-All Calls-Pri - NEC NEAX 2400 IPX Programming Manual

MULTIPLE CALL FORWARDING-ALL CALLS-PRI

M-75 MULTIPLE CALL FORWARDING-ALL CALLS-PRI
1. General Description
This feature permits a call from the ISDN network to a station set to CALL FORWARDING-ALL CALLS-PRI
[C-95] to be forwarded multiple times to a predesignated idle station.
2. Operating Procedure
To set CALL FORWARDING-ALL CALLS-PRI[C-95] from an individual station:
1. Lift the handset; receive Dial Tone.
2. Dial the specific CALL FORWARDING-ALL CALLS-PRI access code; receive Special Dial Tone.
3. Dial the desired target station number; receive Service Set Tone.
To cancel CALL FORWARDING-ALL CALLS-PRI[C-95] from an individual station:
1. Lift the handset; receive Dial Tone.
2. Dial the specific CALL FORWARDING-ALL CALLS-PRI cancel code; receive Service Set Tone.
To set CALL FORWARDING-ALL CALLS-PRI[C-95] from the ATTENDANT CONSOLE [A-3]:
1. Press an idle "LOOP" key.
2. Dial the specific CALL FORWARDING-ALL CALLS-PRI access code; receive Special Dial Tone.
3. Dial the TENANT [T-12] number (2 or 3 Digits).
4. Dial the originating station number.
5. Dial the desired target station number; receive Service Set Tone.
To cancel CALL FORWARDING-ALL CALLS-PRI[C-95] from the ATTENDANT CONSOLE [A-3]:
1. Press an idle "LOOP" key.
2. Dial the specific CALL FORWARDING-ALL CALLS-PRI cancel code; receive Special Dial tone.
3. Dial the TENANT [T-12] number (2 or 3 Digits).
4. Dial the originating station number; receive Service Set Tone.
3. Programming
STEP 1: ASYD - System Data 1, Index 4, bit 6: One burst of ringing at forwarding station when
CHAPTER 5
Page 114
Revision 1.0
Index 69,bit 1:
System Data 2,Index 6,bit 4:Enable stations set for MULTIPLE CALL FORWARDING-
MULTIPLE CALL FORWARDING-ALL CALLS is in
service?
0/1: No/Yes.
A burst of Ringback Tone to alert the person receiving a call
that this is a MULTIPLE CALL FORWARDING-ALL
CALLS call. In service? 0/1: No/Yes. Normally assigned
as data "0".
ALL CALLS be allowed to use their phones normally. If
data "0" is assigned, the station will only be able to call
the Attendant Console. Assign on a per-tenant basis.
NDA-24305