Boss-Secretary Transfer-Pri - NEC NEAX 2400 IPX Programming Manual

B-19

BOSS-SECRETARY TRANSFER-PRI

1. General Description
This service feature allows a secretary to voice-announce a call to a boss when the secretary answers a call from
an ISDN trunk on the boss' line.
2. Operating Procedure
1. Call terminates to boss' line.
2. Secretary answers the call on Boss' line of Secretary's D
3. Secretary presses boss' line key; incoming call is placed on hold, a signal tone is transmitted over the
speaker of boss' D
The LCD displays (Boss and Secretary):
4. If the "MIC" key of boss' D
5. Secretary hangs up (
line is placed on hold. At this time, boss' line of Secretary's D
answer the held call at any time. (
6. Boss lifts the handset, presses the boss' line key, and answers the call. The LCD is displayed:
term
[D Series III]
XFR
(Time Display)
Note 1: If the boss is talking on another line or has a single line telephone, boss' station rings and VOICE
CALL [V-2D] cannot be activated.
If the boss answers before the secretary hangs up, the boss will talk to the secretary. At this time, the
Note 2:
secretary can talk to the incoming call, to the boss by pressing the boss' line key or the transfer key.
If the boss doesn't answer the held call in a specific time, secretary will be recalled by the held call.
Note 3:
3. Programming
STEP 1: ASFC - Assign SFI 51=1 (Boss-Secretary is in service) to the secretary station.
STEP 2: AKYD - Boss' My-line must be assigned as a sub-line on the secretary's phone.
Note: Secretary must have D
term
, and boss and secretary can talk by VOICE CALL-D
ICM
(Time Display)
term
is on, Boss can converse HANDS FREE-D
Note 2 ); a signal tone is transmitted over the speaker of boss' D
)
Note 3
XXXX
term
for this operation. Boss may have a single line telephone.
term
.
XXXX
term
is placed on hold, too, and secretary can
term
[D Series E]
TRANSFER
(Time Display)
NDA-24305
BOSS-SECRETARY TRANSFER-PRI
term
[V-2D]. Note 1
term
[H-4D].
term
again, and boss'
XXXX
CHAPTER 5
Page 37
Revision 1.0