NEC NEAX 2400 IPX Programming Manual page 197

3. Service Conditions
1. This feature is available since Series 7400 Release 9 software.
2. This feature is available on condition that the system data is assigned to allow OAI service (see
PROGRAMMING).
3. This feature is not provided for Calling Name information transmission to NI-2 network.
4. Calling Name information received from NI-2 network can be displayed on D
5. A maximum of 15 digits of Calling Name information received from NI-2 network is included in the facility
information element. The number of digits may depend on the system data assignment (see
"Programming").
6. The system does not check the contents of Calling Name information received from NI-2 network.
7. (The system displays or transmits Calling Name information as received from NI-2 network.)
8. When the Calling Name information received from NI-2 network is the information of intermediate party
(when NI-2 is the intermediate interface of the tandem connection), the information is not displayed on the
terminal nor transmitted to the destination.
9. When the destination sets the call forwarding service, the Calling Name information is also transmitted
(forwarded) to the forwarded destination (This condition is applied to both cases the forwarded destination
is in the same network and in other networks such as CCIS or Q-SIG, FCCS).
10. Calling Name information received as FACILITY message is not transmitted to CCIS or Q-SIG line (Calling
Name information in SETUP message only).
11. When the Calling Name information is not sent from NI-2 network (if the information notification is
rejected), no Calling Name information is displayed on terminals or transmitted to the destination.
4. Programming
STEP 1: ASYD - SYS1, Index78, bit5=1: Name Display service is provided
STEP 2: ARTD/ARTDN- Assign the route class data of NI-2 trunk.
bit3: Dialed number display is;
0/1=Not available/Available
Index79, bit6=0: OAI service is provided
Index241, bit1: Maximum number of digits displayed for Name Display service
0/1 = 8 digits/16 digits of the first part
DPLY (CDN50): 1 = Connected party number is displayed on D
inter-office connection
IND (CDN112) : 1 = Inter-office Name Display service is in service
NDA-24305
NETWORK NAME DISPLAY (NI-2 PRI)
term
or PS terminal only.
term
for
CHAPTER 6
Page 179
Revision 1.0