NEC NEAX 2400 IPX Programming Manual page 229

3. Programming
STEP 1: Assign the Basic Data for ISDN.
STEP 2: ASYD - Assign the following system data for CCIS
Note: ISDN transmitting information service is necessary for the transparency of ISDN information between
ISDN and CCIS No. 7 network.
STEP 3: ARTD - Assign the following route class data for CCIS Trunk
ROUTE FOR SIGNAL CHANNEL
STEP 4: ARTD - Assign a following data to the speech route of CCIS No. 7.
CALLING PARTY INFORMATION TRANSFER/TRANSFER MESSAGE (TRM)
SYS-1 Index 4, b4:
Index 82, b4-b7: Station Number Display Pattern on the ATTCON
Index 180&181: Originating Point Code
Index 182&183: Centralized Billing Point Code
Index 184&185: Centralized Management Report Point Code
Index 186:
Index 187:
Index 188, b0:
Index 189, b4-b7 ACM, UBM Signal "No-Receiving" Timer (Normally assign
(Signal Channel & Speech Channel)
• OSGS = 0
• ONSG = 2
• ISGS = 0
• INSG = 2
• TCL = 4
• L/T = 1
• RLP = 2
• LSG = 13
• ANS = 0
• PAD = 7
• BT = 0
• DPLY = 0
• LYER1 = 0
• NET = 0
• INT = 0
CDN98 (CI) ISDN transmitting information.
0= Out of service
→ 1=
16-Digit Caller Number Service, Attribute Information Notification service,
and Calling Sub-Address Transfer Service.
2-15= Not used.
Assign data "1" in this CDN.
Note
Temporary Class Conversion
0/1=Not Required/Required. (always assign "1")
Service Check
Number of CCH/DCH cards
(always assign 00 Hex)
No. 7 CCIS Control System Interoffice Audit Test
0/1=Not Required/Required.
F0 Hex.)
ROUTE FOR SPEECH CHANNEL
• OSGS
• ONSG
• ISGS
• INSG
• TCL
• L/T
• RLP
• LSG
• ANS
• PAD
• BT
• DPLY
• LYER1
• NET
• INT
NDA-24305
= 0
= 2
= 0
= 2
= 4
= 1
= 2
= 12
= 1
= 4
= 1
= 1
= 0
= 0
= 0
CHAPTER 6
Page 211
Revision 1.0