Commands; 2.1 Asyd: Assignment Of System Data - NEC NEAX 2400 IPX Programming Manual

COMMANDS CONCERNING ISDN DATA ASSIGNMENT

2. COMMANDS

2.1 ASYD: ASSIGNMENT OF SYSTEM DATA

SYSTEM
SYSTEM DATA
DATA
DATA (DATA)
INDEX
TYPE 00-FF
(INDEX)
(SYS) (Hex)
0-511
76
1
186
187
CHAPTER 4
Page 18
Revision 1.0
BIT CORRE-
SPONDING
DATA
DATA
BIT
0/1
0 b Not used
0
b Same Number Special Access Code
1
Data (ASPS command)
0/1 = Common/Separate
b Call Forwarding Service by Calling
2
Number Data (AFCP command)
0/1 = Common/Separate
0 b Not used
3
0 b
4
0 b
5
0 b
6
0 b
7
b 0/1 = Link Re-Connection Not Involved/Link Re-Connection
0
Note:
b Restriction check based on the caller's restriction class when the
1
outgoing trunk is using the No. 7 CCIS in a tandem connection.
0/1 = No Check/Check
0 b 0/1 = -/No. 7 CCIS Loop-Back Test in progress
2
0 b Not used
3
b Serial Call-Loop Release:
4
0/1 = Out (CCSA key)/In Service (No CCSA key)
b Clearing of the buffer memory for use in the centralized
5
management report (For CCIS).
0/1 = not necessary/necessary
b CCIS or ISDN:
6
0/1 = Out/In Service
b Centralized IC Billing Office Code:
7
0/1 = Ineffective/Effective
00 Data Bus used for CCIS/ISDN cards (Assign 00 Hex)
SYSTEM DATA CONTENTS
Involved
An Interoffice transfer service is available. For example,
with No. 7 CCIS, a caller has called outside their own
office but is actually talking with somebody in their own
office. This bit is used to reconfigure links so they are not
wasted in call transfer service.
NDA-24305
Table Development:
Common or Separate
Day/Night Data Tables.
Note: When data
tables are
designated as
"Common",
the Day mode
designation
must be used
in the
respective
commands.