NEC NEAX 2400 IPX Programming Manual page 253

STEP 4: ARTI - Assign the following data for the E-CCIS route.
JECCIS (Common use with E-CCIS RT):1
ECCISTIM: Release Timer for the E-CCIS line
ECCISOB:
ECCISIB:
ECCISTD:
ECCIS2 (E-CCIS System): 1=Common Channel System
STEP 5: AEVT - Assign the virtual tie line data for E-CCIS.
FUNC:
RT:
TK:
TYPE:
DESTINATION: Destination Number (Max. 6 digits)
CALLING:
CALLED:
ISDN_RT:
VRY:
FUNC:
PC:
RT:
Note: When Verification of Connection is in service, if the last four digits of the received number is not equal to
those of Called Number, the connection is not established.
STEP 6: AVTC - Assign Virtual Tie Line Number for the E-CCIS route.
0: 3 minutes (Default)
1: 15 seconds
2: 30 seconds
3: 1 minute
4: 2 minutes
5: 5 minutes
6: 10 minutes
7: 15 minutes
8: 30 minutes
9: 1 hour
10-13: Not used
14: Immediately after call completion
15: Not released
OG Billing for E-CCIS Line
0/1=Not required/Required.
IC Billing for E-CCIS Line
0/1=Not required/Required.
Addressing information used in E-CCIS
0/1=Called DID Number/Called Sub Address.
1
Route Number
Fixed "0"
3 (Common Channel System)
Calling Number (Max. 24 digits)
Called Number (Max. 24 digits)
ISDN Route Number
Verification of Connection
0/1=Not required/Required
2
Terminating Point Code
E-CCIS Route Number
NDA-24305
EVENT BASED CCIS - Q-SIG TRANSPORT
Note
CHAPTER 6
Page 235
Revision 1.0