Setting System Data Copy - NEC UNIVERGE SV9300 Networking Manual

SETTING SYSTEM DATA COPY

(1) To copy the system data from the Main Unit to Remote Units automatically once a day;
START
CM43 Assign the start time for copying the system
data from the Main Unit to Remote Units.
NOTE 1:
NOTE 2:
NOTE 3:
END
(2) To copy the system data from the Main Unit to Remote Units manually/To read the state of system
data copy;
START
CMEC Specify the unit number that is executed the
system data copy /read the state of system data
copy.
NOTE:
END
DESCRIPTION
The state of automatic system data
copy can be read by CMEC Y=8.
System data copy is executed from
the low Remote Unit number to high
Remote Unit number.
The start time for system data copy
may gain/loss about three minutes
from the time you set.
DESCRIPTION
You can assign only "0" to the
second data. "1" is displayed in the
second data while the system data
being copied.
Chapter 3 REMOTE UNIT OVER IP FEATURES
• Y=7
(1) 00
(2) HH MM
HH
MM
9999
NONE : 0200 (2:00 a.m.)
• Y=8
(1) 00 : All Remote Units
02-50: Remote Unit02-50
(2) 0 : Start System Data Copy
1 : Now copping/System data copy state
can be read
3 : Stand by/System data copy state can
be read
3-31
SETTING SYSTEM DATA COPY
DATA
: 00-23 (Hour)
: 00-59 (Minute)
: Not copy the system data auto-
matically
DATA
NWA-088654-001 Rev.1.0
94ch3001.fm