Route Advance Assignment - NEC UNIVERGE SV9300 Networking Manual

Route Advance Assignment

To provide the Alternative Routing (another trunk route) for CCT when an outgoing call via No. 7 CCIS
is not available due to a fault occurrence, do the following programming.
START
CM35 Provide the voice channel route of CCT with
Alternative Routing for a fault occurrence.
Provide the tandem calls with Alternative
Routing for a fault occurrence.
CM08 Provide the system with Alternative Routing
of CCIS outgoing call when all outgoing
trunks of tandem office are busy.
CM41 Set the PBR timer when establishing a tandem
connection.
NOTE:
CM29 Assign a Numbering Plan Group to each ten-
ant.
CM20 Assign the access code for LCR Group 0-3.
CM90 Assign a service access key for LCR Group 0-
2 to Multiline Terminal, if required.
A
DESCRIPTION
Usually, it is recommended to set the
second data to 33 (33 sec.).
• Y=186
(1) 00-63: Trunk Route No.
(2) 0 : To provide
1 : Not provided
• Y=192
(1) 00-63: Trunk Route No.
(2) 0 : To provide
1 : Not provided
(1) 372
(2) 0 : To provide
1 : Not provided
• Y=0
(1) 104
(2) 02-99: 02-99 seconds
(1 second increments)
If no data is set, the default setting is 7 seconds.
(1) 00-63: Tenant No.
(2) 710-713 : Numbering Plan Group 0-3
NONE : Numbering Plan Group 0
• Y=0-3 Numbering Plan Group 0-3
(1) X-XXXX: Access Code
(2) A126: LCR Group 0
A127: LCR Group 1
A128: LCR Group 2
A129: LCR Group 3
• Y=00
(1) My Line No. +
(2) F0A26-F0A28: LCR Group 0-2
1-64
Chapter 1 CCIS FEATURES
CCIS BASIC PROGRAMMING
DATA
,
+ Key No.
NWA-088654-001 Rev.1.0
94ch1002.fm