Mitsubishi Electric MELSEC iQ-R Series User Manual page 190

■Replacing a parameter unique to the station
The following describes the method of replacing a parameter unique to the station.
Ex.
To use the same program for stations No.2 and No.3, replace the assignment of the stations No.2 and No.3.
• For MELSEC-Q series
CPU device
Station No.1
B0000 to B01FF
Station No.3
B0200 to B02FF
Station No.2
B0300 to B03FF
·
(1) Refresh parameter
(2) Parameter unique to the station
• For MELSEC iQ-R series (RJ71LP21-25)
CPU device
Station No.1
B0000 to B01FF
Station No.3
B0200 to B02FF
Station No.2
B0300 to B03FF
·
(1) Refresh parameter
Precautions
The number of refresh parameters that can be set is 64. When more than 65 parameters unique to the station are set, it is
required to review the refresh range or perform refresh with the program.
■Method of replacement for simple redundancy
The refresh parameter in the network can be replaced with the refresh by instructions using the link direct device (J \ B,
J \ W).
For details on the method of replacement for multiplex transmission, refer to the following.
 Method of replacing High Performance model QCPU with Universal model QCPU (FA-A-0001)
APPX
188
Appendix 7 Differences Between MELSEC-Q Series and MELSEC iQ-R Series
Link device
(1)
Station No.1
LB0000 to LB01FF
Station No.3
LB0200 to LB02FF
Station No.2
LB0300 to LB03FF
·
Link device
(1)
Station No.1
LB0000 to LB01FF
Station No.2
LB0300 to LB03FF
Station No.3
LB0200 to LB02FF
·
Network range assignment
(2)
Station No.1
LB0000 to LB01FF
Station No.2
LB0200 to LB02FF
Station No.3
LB0300 to LB03FF
·
Network range assignment
Station No.1
LB0000 to LB01FF
Station No.2
LB0200 to LB02FF
Station No.3
LB0300 to LB03FF
·