Setting parameters in the normal station
Connect the engineering tool to the CPU module on the normal station and set parameters.
1.
Set the CPU module as follows.
[Project] [New]
2.
Click the [Setting Change] button to set the module label to be used.
3.
Set the RJ71LP21-25 as follows.
[Navigation window] [Parameter] [Module Information] Right click [Add New Module]
4.
Add the module label of the RJ71LP21-25. The addition method of the module label is the same as that of the control
station. ( Page 82 Setting parameters in the control station)
3 PROGRAMMING
3.2 Program Examples of the Redundant System
3
85