Panasonic FP2-PP2T Technical Manual page 225

Offset
Name
address
JOG operation
02AH acceleraiton
time
JOG operation
02BH deceleration
time
02CH
JOG operation
target speed
02DH
02EH -
02FH -
030H -
031H -
032H -
Emergency stop
033H deceleration
time
034H -
Limit stop
035H deceleraiton
time
036H -
Error stop
037H deceleration
time
Pulser operation
038H
setting code
Descriptions
Sets the acceleration/deceleraion time when performing the JOG operaiton.
At the beginning of the JOG operation, accelerates for the specified acceleration
time, decelerates for specified deceleraiton time when the starting contact of the
JOG operation turns off, and stops.
Sets the target speed when performing the JOG operation.
After starting the JOG operation, accelerates with the specified operation to the
target speed while the starting contact of the JOG operation is on. After reaching
the target speed, operates with the target speed.
-
-
-
-
-
When the emergency stop is requested by I/O, it will be valid, and the deceleration
operation will complete in this deceleration time.
-
When the limit is input, the deceleration operation will complete in this deceleration
time.
-
When an error occurred, it will be valid, and the deceleration operation will
complete in this deceleration time.
Specify one pulser among 1 to 3 for the input, for the case that pulser operation is
requested by I/O.
Default Setting
Unit
value range
17-35