ABB GOE 2600 Installation And Commissioning Manual page 23

4. Carefully lift the bushing from the floor.
5. Lift the bushing up from the floor with both cranes.
1. Lift the upper part of the bushing. Stop when
the bushing is in a vertical position.
2. Remove the lower soft lifting slings to the
crane.
3. Remove the flange lifting tool (88).
6. Lift the bushing to a position above the transformer.
7.
Align the bushing with the hole in the transformer turret.
End of instruction
Installation and commissioning guide
1ZSC000563-AAF EN, REV. 4, 2021-06-23
CAUTION!
Make sure that the bushing does not
rotate.
CAUTION!
Do not let the bushing come in contact
with the floor while raising the bushing
to a vertical position. Contact with the
floor can cause damage to the
bushing.
CAUTION!
Make sure that the bushing does not rotate.
23