Table of Contents
Advertisement
5.
Lift the bushing to a position above the floor and
turn the bushing to a horizontal position.
1.
Install the lifting tool (88) to the flange.
2.
Install soft lifting slings from the lifting tool
(88) to a second crane.
3.
Lower the upper part of the bushing. Stop
when the bushing is in a horizontal position.
6.
Lower the bushing to the floor.
7.
Remove the lifting tool, refer to Installation of lifting tools, page 20.
8.
Install the transport cover (13) on the transformer
turret (11).
End of instruction
70
CAUTION!
Do not let the bushing come in contact
with the floor while lowering the
bushing to a horizontal position.
Contact with the floor can cause
damage to the bushing.
CAUTION!
Make sure that there are support blocks on the floor.
Installation and commissioning guide
1ZSC000563-AAF EN, REV. 4, 2021-06-23
Advertisement
Table of Contents
