ABB GOE 2600 Installation And Commissioning Manual page 38

5. Put the pull-through cord (12) through the
box-spanner (13).
6.
Apply Molykote Multilube to the thread on the
pull-through cord (12), and then connect it to the
draw rod.
7. Remove the M16 nut (10), and washer.
8. With a soft cloth, carefully clean the bottom end of the bushing, and the inside of the center hole. Look
for damage.
38
NOTE!
Or use a lubricant with equal properties
to Molykote Multilube.
Installation and commissioning guide
1ZSC000563-AAF EN, REV. 4, 2021-06-23