ABB SACE Emax 2 Series Operating Instructions Manual page 134

Bluetooth Low Energy -
Parameters
131 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
The following parameters are available
Parameter Description
Enables/disables Bluetooth Low Energy antenna switch-on and
availability of the other parameters in the menu:
Enable • if On , the antenna comes on, on the basis of the Battery Mode
parameter configuration
• if Off , the antenna is off
Defines the switch-on mode of the Bluetooth Low Energy antenna,
based on the presence of the devices on the service connector (Ekip
T&P, Ekip Programming, Ekip TT); can have two values:
• --- ; with this option, the state of the antenna depends esclusively on
the presence of devices: on if not present; off if present
• ON; with this option, the antenna is switched off for 15 seconds when
Battery mode a device is connected, after which it remains off if communication with
the device has been activated; it comes on if no communication has
been activated
IMPORTANT: the typical scenario in which Battery mode should
be configured = On is: Ekip Touch + Ekip TT + communication
with smartphone activated; in all other cases, including System
Update, configure Battery mode = ---
Command which starts Pairing between Trip unit and external device.
To perform the operation correctly:
1. Press Connect on EPiC APP, select the Trip Unit from among the units
in the list and then select Connect again
2. Press Start Pairing in the Trip unit menu, enter the PIN, then press
Start Pairing again
3. Press Start Pairing on EPiC APP and confirm the operations until the
code request appears
Start Pairing 4. Check that the pop up with the Passkey appears on the display of the
Trip unit (about 20 seconds) and enter it in EPiC APP
5. The Trip unit will be connected to the external device from this
moment on; for the successive re-connections, it will be sufficient to
just repeat point 1
NOTES:
• execute the procedure within 120 seconds
• the command is not available if communication with a device is
activated
Command that deletes the list of devices coupled to the Trip unit
Decouple
NOTE: the command is not available if communication with a
devices
device is activated
Version FW version of the Bluetooth Low Energy module installed on board
IMPORTANT: when Bluetooth Low Energy antenna is on, communication on the service
connector is not available
IMPORTANT: if Bluetooth is disabled during the order (with the extracode) or disabled
by a Service L3 authorized person, the dedicated menu will neither be present, nor visible
nor usable. The icons will not be shown on the screen if Bluetooth is disabled
ABB | SACE Emax 2
Default
Off
---
---
---
---
Ekip Touch - Settings
1 - Main settings