Ekip Touch - Protections; Protections - Introduction - ABB SACE Emax 2 Series Operating Instructions Manual

Ekip Touch - Protections

1 - Protections - Introduction

Operating principle The protection functions are available with all Ekip Touch models and versions.
References Many of the protection thresholds are displayed in two different quantities: absolute value and relative
Protections packages The protections described in the following chapters are grouped into packages, the availability of which
54 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
Each protection is associated with a different signal (current, voltages, frequencies, powers, etc) but the
operating principle is the same:
If the signal measured exceeds the set threshold, the specific protection activates (prealarm and/
1.
or alarm condition).
The alarm appears on the display and, after a period of time (timing t
2.
protection parameters set, can convert into a trip command (TRIP) transmitted to the internal
Trip Coil of the CB.
NOTE:
• if the signal measured drops below the set threshold before the trip time has elapsed, Ekip
Touch quits the alarm and/or timing status and returns to the normal operating condition
• all protections have a default configuration: check the parameters and change to suit the
installation requirements before putting into service
value.
The relative value depends on the type of measurement:
Type of protection Reference
Current In
Voltage Un
Frequency fn
Power Sn
depends on the model and version of the Trip unit, and on their ability to be installed as additional
package:
Package
Standard Protections
Voltage protections
Voltage Advanced protections
Frequency protections
Power protections
ROCOF protections
Adaptive protections
Additional protections and functions
Description
Nominal current of the Rating plug
Line-to-line voltage setting
Frequency setting
√3 x In x Un
Page
55
65
68
72
75
81
82
83
Ekip Touch - Protections
1 - Protections - Introduction
ABB | SACE Emax 2
), depending on the
t