ABB SACE Emax 2 Series Operating Instructions Manual page 136

Test Bus The parameter allows parameter editing via the service connector to be enabled/disabled, thereby
System The System menu provides various options:
Maintenance The parameter allows an alarm, concerning maintenance of the unit, to be enabled/disabled. (page 116).
133 | © 2023 ABB | 1SDH001330R1002 - ECN000297030
limiting the possibility of configuring all the options on the display (in the Local mode) or via modules
Ekip Com (in the Remote mode).
Disabling the parameter, Local mode and using the PIN allow security against undesired modification by
unauthorized persons to be increased.
NOTE: with Test Bus= Off, communication via service connector is still guaranteed (reading
enabled)
Ekip Touch is supplied with the parameter set to: On.
Parameter Description
Date Setting the current date
Time Setting the current time
Language Setting the language in display menus
PIN PIN setting (page#s#53)
IMPORTANT: setting and checking Date and Time is important for all the recording
functions (trips or measurements); in the event of date and time glitches, reset and if
necessary replace the battery inside Ekip Touch (page 291).
View The View menu provides various options:
Parameter Description
Enables the orientation of the Alarms List , Measuring Instruments
TFT orientation and Main Measurements pages to be set. The options are: Horizontal,
Vertical clockwise, Vertical counter-clockwise
Allows you to activate a supplementary information page, which can
be accessed by pressing the iTEST button twice from any page with a
Customer page
diagnosis bar. The information on the new page can be configured via
Ekip Connect (page#s#135)
Allows the current to be displayed in the Measuring instruments page
Ammeter
to be set from among the following options: Imax, I1, I2, I3, Ne (only in
Phase
the 4P or 3P + N configuration)
Voltmeter Allows the voltage to be displayed in the Measuring instruments page
Phase
to be set from among the following options: Vmax, V12, V23, V31
Ekip Touch is supplied with the parameter set to: On.
ABB | SACE Emax 2
Default
English
00001
Default
Horizontal
Off
Imax
Vmax
Ekip Touch - Settings
1 - Main settings