HP D7171A - NetServer - LPr Installation Manual page 107

Chapter 10
l
Configure Remote Management:
This utility configures the Integrated Remote Management device for
remote management. It enables remote dial-up HP NetServer management.
To configure Integrated Remote Assistant, select Configure Remote
Management on the Configure Remote Management screen.
l
Show System Information:
Use this screen to display information about standard and accessory boards
and devices in the system, as well as the used and available system
resources.
Select View Hardware Inventory on the Show System Information
screen to display information about standard and accessory boards and
devices in the system.
Select View Resources on the Show System Information screen to
display used and available system resources such as memory ranges,
I/O port ranges, DMA channels, and interrupt (IRQ) levels.
l
Configure Disk Array:
This configures your HP disk array, but requires you to fill out the Disk
Array Configuration Worksheet before proceeding. Click Help for more
details.
NOTE When you configure an array, the default cache mode is
write-through. For write-back mode, install the optional battery
back-up accessory.
l
Install Utility Partition:
This setup creates a 32 MB DOS-based utility partition on the NetServer
hard disk where HP Navigator will copy DiagTools, the BIOS Update
utility, the Event Log Report utility, the Disk Array utility, the NIC
Configuration utility, the Integrated Remote Assistant utilities,
troubleshooting utilities, and other utilities. A Utility Partition is not
available for SCO UnixWare.
Select Execute on the Install Utility Partition screen.
NOTE
This is useful if you lose your HP NetServer Navigator
CD-ROM. Once you install the NOS, you cannot use this utility
partition.
Configuring the HP NetServer
99