Step 2: Install The Slides In The Rack - HP D7171A - NetServer - LPr Installation Manual

Chapter 8 Mounting the HP NetServer in an HP Rack System/E or Rack System/U
server requires.) The template directs you to the second and fourth holes on
the rack column that are used for mounting the slide. Mark these holes
from the baseline (bottom) for future reference.
3. Hold the template against the front face of the left-rear rack column (as you
are looking from behind the rack). The template directs you to second and
fourth holes in the rack column. Mark them from the baseline for future
reference.
4. Repeat Steps 1 through 3 for the right-front and right-rear columns.

Step 2: Install the Slides in the Rack

This step explains how to install the LT 6000r slides in the rack.
Figure 8-3. LT 6000r Rack-Mount Slide Features
NOTE
To differentiate between both slides, the right-hand slide is
marked with an R embossed on the outside; the left-hand slide
is marked with an L. Arrows pointed up are embossed on the
outside of each slide to show the correct orientation.
81