Removing A Hot-Plug Accessory Board - HP D7171A - NetServer - LPr Installation Manual

Chapter 6
3. Scroll down the list, and select NetServer LT 6000r.
4. Select Install.
5. Select Installing Accessory Boards.
6. Select the appropriate Hot-Plug Replacement topic.
NOTE
To perform a hot add or a hot replacement when the
NetServer is powered on, refer to the PCI Hot-Plug Help
file on the HP NetServer Navigator CD-ROM.

Removing a Hot-Plug Accessory Board

To remove a hot-plug board from the NetServer, which is not powered on, follow
these instructions:
1. Open the accessory board access panel.
2. Open the locking lever and retainer.
3. Pull on the blue plastic slot separator that corresponds with the accessory
board you are removing until you feel resistance. This releases the
hot-plug board from the I/O board connector.
NOTE
The plastic slot separator cannot be removed when removing
an accessory board from its slot.
4. Remove the hot-plug board from the slot.
5. Replace the hot-plug board or re-install the slot cover.
6. Close the retainer and locking lever.
Installing Additional Boards
65