Chapter 8
Mounting the HP NetServer in an HP Rack System/E or Rack System/U
7. Open the bezel, and turn the key lock on the right-hand side of the
LT 6000r's front panel to prevent the server from being released from the
rack.
8. Close the bezel.
9. Refer to the Rack Mount Cabling Reference Guide on the HP NetServer
Navigator CD-ROM for information about installing the LT 6000r's
Cabling Management Arm and other cabling instructions.
Step 4: Install the Cable Management Arm
The LT 6000r's cable management arm (Figure 8-11) is used to route all power
cords and cables from the NetServer. It is attached to the left-hand rear panel of
the NetServer and the left rear column on the rack.
Rack bracket
Figure 8-11. LT 6000r Cable Management Arm
Use these instructions to install the arm:
1. Install the chassis bracket to the left-hand rear panel of the NetServer as
shown in Figure 8-12.
a. Install two Torx 6-32 screws into the mounting holes on the chassis.
b. Fit the chassis bracket holes over the screws so that it locks into place.
c. Tighten the screws to secure the chassis bracket to the rear panel.
88
Chassis bracket