HP D7171A - NetServer - LPr Installation Manual page 114

Chapter 10
and disabling HotADD Reserved Resources. Configuring the
multi-processor (MP Specification Version) feature is done from here,
too.
Boot Setting: Use this menu to check the flexible disk drive, display
the NetServer's configuration at boot time, skip certain tests during the
boot process to speed up boot time, or change the (default) boot order,
including device type, network boot, and hard disk drive boot order.
Embedded LAN & SCSI Setting: Use this menu to do the following:
Change between HP NetRAID (default) and LVD SCSI modes.
Enable and disable the Wake-On-Line feature.
Keyboard & Mouse Settings: Use this menu to set the parameters of
the keyboard, including NumLock, and set the PS/2 mouse to Auto
(detect)/Enabled/Disabled. Disabling the mouse frees up IRQ 12, but
prevents any installed PS/2 mouse from functioning.
Flexible Disk & IDE Settings: Use this menu to enable/disable the
local bus IDE drive. Use this menu to change the flexible disk type or
add an IDE hard drive to HP NetServer's configuration. This would
include selecting the hard disk drive's characteristics, manually or
automatically, and selecting which drive will be the primary master or
slave, the CD-ROM, or the IDE hard disk drive.
Processor/Memory Settings: Use this menu to enable the processor
module's serial number (if supported) being read by firmware, enable
memory caching, and/or add an extended memory gap in system
address space.
l
Security: Two submenus are provided:
Power-On Password: Sets the administrator and user passwords, and
sets the system requirement for a password after booting.
The administrator password must be set before setting the user
password. Once the administrator password is set, the administrator can
access and change all fields in the screens.
If the user password is set, the user can change only the system time,
date, and user password. The user can view all fields, but cannot alter
any of the settings.
Hardware Security: Sets the system parameters for operating in
Secure Mode.
l
Exit: Exit the Setup Utility by saving changes or exit without saving
changes, which reverts to previous settings.
When you exit, the HP NetServer reboots.
106
Configuring the HP NetServer