Using The Setup Screens; Changing The System Date And Time - HP D7171A - NetServer - LPr Installation Manual

Chapter 10

Using the Setup Screens

Online help explains the settings displayed on the Setup Utility screens.
Instructions are also provided for navigating between the screens, and entering or
changing the setup data.
l
Press the right-arrow and left-arrow keys to move between selections on
the menu bar. The menu bar is present at the top of the main selections.
l
Press the up-arrow and down-arrow keys to move between fields on
each screen. The currently selected field is highlighted.
l
Certain fields ask you to choose from a list of entries. In such cases, press
the plus (+) or minus (-) keys repeatedly to display each possible entry or
the Enter (or Return) key to choose from a pop-up menu.
l
Pointers precede some field names. This means the field contains a
submenu. To visit the submenu, select it with the arrow keys, and press the
Enter key. The submenu appears in place of the current screen.
l
The Esc key is the exit key. If you press the Esc key on one of the top-
level screens, the Exit menu appears. If you press the Esc key on a
submenu, the previous screen appears. When you are making selections
from a pop-up menu, use the Esc key to close the pop-up menu without
making a selection.

Changing the System Date and Time

To change the HP NetServer's date and time, refer to the following procedure:
1. To reach the Setup Utility, boot or reboot the system, and press [F2] when
prompted.
Once in the Setup Utility, the menu bar appears at the top of the screen
with "Configuration, Security, and Exit" shown. The Configuration menu
is the default menu, and should be the highlighted selection at the left of
the menu bar when the Setup Utility first opens.
2. If necessary, use the left-arrow key to select Configuration from the menu
bar at the top of the screen.
3. If necessary, use the left-arrow key to select the System Time field.
The "System Time" field is highlighted by default when the
"Configuration" menu is selected. This field actually consists of three
sub-fields, enclosed in brackets [xx:xx:xx] hours to the left (24-hour
clock), minutes in the middle, seconds to the right.
4. Type in the hour, and press Enter to move to the minutes field.
Configuring the HP NetServer
107