Chapter 6
Figure 6-3. Removing the PCI Slot Cover
8. Before installing an accessory board:
Verify that there is no extender attached to it, especially if it is a
full-length board.
If the board has a extender attached to it, remove the extender before
installing the board.
9. Align the full length of the board with its slot and position it into the slot.
NOTE
For instructions on installing a PCI accessory board in Slot 1,
see the subsection "Installing an Accessory Board into Slot 1."
CAUTION
Do not bend the accessory board when installing it.
All accessory boards are held in place with the PCI lever and
retainer. Full-size boards are supported when seated in the
card guides.
(Locking Levers and Retainers Shown)
Installing Additional Boards
55