Chapter 13
Step 1: Mark the LT 6000r's Position in the Rack
Use the rack-mount template to mark out four EIA units for positioning the
LT 6000r in the rack.
NOTE
Use the HP Rack Assistant software to determine where to
mount the HP NetServer in the rack.
CAUTION
Be sure to compensate for any other components that might be
mounted in the rack. Install these components before
mounting the LT 6000r.
1. Pull the anti-tip foot out of the bottom of the rack.
134
Figure 13-2. Anti-Tip Foot
Alternative Rack Mounting