Front Panel Console; Power Switch - HP D7171A - NetServer - LPr Installation Manual

Chapter 2

Front Panel Console

Figure 2-2 shows the LT 6000r front panel console.
Table 2-1. Front Panel Console Switch and Indicator Definitions
Control
Secure Mode Indicator
DC Power Switch
and LED
10
Figure 2-2. Front Panel Console
Description
Locks system keyboard, monitor display, and control panel to
prevent unauthorized use. Go to the Setup utility security menu
to configure this feature.
Turns the HP NetServer on and off. This switch is under the
protective door on the front panel. Push once to turn on,
again to turn off. As long as the AC power is connected to
the HP NetServer, standby power is present.
l
If the LED is steady green, then the HP
NetServer is powered-up.
l
If the LED is flashing green, the HP NetServer is
in a power-save mode.
l
If the LED is off, but the two-line display has a
message, standby power is present.
l
If the HP NetServer is set up to go into
power-save mode, the power switch is
depressed; you must press it for over four
seconds to effect a power down.
Controls, Indicators, and Ports