HP D7171A - NetServer - LPr Installation Manual page 70

Chapter 6
Accessory board (full-size) edge
fits under these tangs.
After seating the board
in the tray, push the tray
into the chassis so that
the board' s edge connector
inserts into the slot.
Figure 6-8. Seating the Accessory Board into Tray (Full-Size Board)
8. Slide the tray into the slot so that the board's edge connector is pushed into
the slot connector on the I/O board.
9. Close the retainer over the slot cover (see Figure 6-9).
10. Secure the accessory board by rotating the locking lever counter-clockwise
to the hold the retainer (see Figure 6-9).
62
Installing Additional Boards