HP D7171A - NetServer - LPr Installation Manual page 174

Appendix D
3. Power off the NetServer and disconnect all power cords and cables.
4. Locate the "tie-down kit" in the top tray of the shipping container. The
brackets, rack nuts, and screws are in this kit.
5. Insert the rack nuts into the right-front and left-rear columns:
a. On the right-front rack column, insert a rack nut into the second hole
down from the top edge of the NetServer (see Figure D-1).
Figure D-1. Inserting a Rack Nut into the Right-Front Rack Column
b. On the left-rear rack column, insert two rack nuts into the second and
fifth holes down from the top edge of the NetServer (see Figure
D-2).
Figure D-2. Inserting Two Rack Nuts into the Left-Rear Rack Column
166
Transporting the HP NetServer