HP D7171A - NetServer - LPr Installation Manual page 92

Chapter 8 Mounting the HP NetServer in an HP Rack System/E or Rack System/U
2. With the help of at least one other person, lift the server by its four
handles, and position it directly over the extended slides.
NOTE The arrows on the sides of the LT 6000r must line up with the
slide's mounting hooks before you lower the server onto the
slides. These hooks fit inside the server as you lower it onto the
slides.
WARNING The LT 6000r weighs up to 100 lbs (45 kgs). At least two
people must be on hand to lift the server into position. Failure
to observe this warning could result in serious injury to you or
damage to the LT 6000r.
3. Lower the server onto the slide members. Ensure that the mounting hooks
have been properly seated inside the chassis (see Figure 8-6).
Figure 8-6. Lowering the LT 6000r onto the Slides
84