Step 3: Mount The Lt 6000R In The Rack - HP D7171A - NetServer - LPr Installation Manual

Chapter 8 Mounting the HP NetServer in an HP Rack System/E or Rack System/U

Step 3: Mount the LT 6000r in the Rack

This step explains how to mount the LT 6000r into the rack.
WARNING
Ensure that the rack's anti-tip foot is fully extended out of the
rack to prevent rack instability while mounting LT 6000r.
Failure to do so could result in injury and equipment damage.
WARNING
To prevent the rack from rolling while you mount the
LT 6000r, make sure that the leveler screws on the rack's
lower four corners are in firm contact with the floor.
1. Fully extend each of the slide members. The slides lock into position. You
cannot push the slides back in the rack without pressing in each slides
release latch. See Figure 8-5.
Figure 8-5. Extending the Slide Members
Slide members
Anti-tip foot
83