Paper Feed Roller; Removing The Paper Feed Sub-Roller Assy - Brother LX-200 Service Manual

3.9 Paper Feed Roller

3.9.1

Removing the Paper Feed Sub-roller Assy

1. Position the chassis unit as shown in the diagram. Release the gear 16 hook from
the paper feed sub-roller assy. Take care not to damage the gear hook by opening
too far.
2. Remove the paper feed shaft spring R and paper feed shaft spring.
Chassis right side
Paper feed shaft spring R
3. Remove the left and right rod holder from the chassis L/R units. Pull the paper feed
sub-roller assy up from the bearings to remove it.
Paper feed sub-roller assy
Paper feed shaft spring
Fig. 3.9-1 Removing the Paper Feed Sub-roller Assy
Paper feed sub-roller assy
Rod holders
Fig. 3.9-2 Removing the Paper Feed Sub-roller Assy
3-26
Gear 16 hook
Chassis left side
Bearings