4.11.2 Reassembling the Sensor Frame
1. Attach the paper sensor harness assy (flat cable) to the FPC holder A and FPC
holder B.
2. Insert the hooks on FPC holder A into slots A in the sensor frame. Attach FPC
holder A by moving it in the direction of the arrow until the hook tip engages in the
groove.
3. Insert the hooks on FPC holder B into slot B and the end hole in the sensor frame.
Attach FPC holder B by moving it in the direction of the arrow until it engages with
the boss holes.
4. Stick new sensor crank protect film aligned with the sensor frame boss, if the film
requires replacing.
FPC holder A
Paper sensor harness assy
Sensor frame
Slot A
Groove
Hook tip
Hooks A
Bosses
Fig. 4.11-2
Reassembling the Sensor Frame
4-20
Boss hole
Slot B
Sensor crank
End hole
protect film
FPC holder B
Hooks B