Installing The Y-Diversion Lever Assy - Brother LX-200 Service Manual

4.8.2 Installing the Y-diversion Lever Assy

1. Mount the Y-diversion lever assy on the X-cutter unit by inserting the left end into
chassis L then the right end into chassis R.
2. Press each of the two Y-cutter assy's against the Y-diversion lever assy and move it
in the direction of arrow 1 up to the position of the Y-cutter guide L/R.
3. Install the Y-cutter guides by lifting the tab on each Y-cutter assy in the direction of
arrow 2, then pushing in the direction of arrow 3 to engage the hook.
3
Y-cutter guide L
Y-diversion lever assy
X-cutter unit
Fig. 4.8-2 Installing the Y-diversion Lever Assy 1
Y-cutter assy
2
1
1
Y-cutter guide R
Fig. 4.8-3 Installing the Y-diversion Lever Assy 2
4-12
2
1 3
2
3