Removing The Chassis Unit - Brother LX-200 Service Manual

3.4.3

Removing the Chassis Unit

1.Remove the sensor frame screw from the sensor frame. Remove the ground wire
(jack PCB). After removing the wire, reinsert the sensor frame screw to fasten
the sensor frame to the chassis.
2.Remove the two bottom cover screws B and the spring washers from under the
bottom cover B.
Ground wire (jack PCB)
Fig. 3.4-3 Removing the Chassis Unit (1)
Bottom cover screws
Fig. 3.4-4 Removing the Chassis Unit (2)
3-13
Sensor frame
Sensor frame screw
Bottom cover