Disassembling The Roller Holder Assy - Brother LX-200 Service Manual

3.7.4

Disassembling the Roller Holder Assy

1. Disengage the two hooks A and remove the side covers L/R.
2. Remove the lock lever springs L/R from inside the lock levers L/R to allow the lock
levers L/R to move freely.
3. Turn hook B on lock lever L to the position of the cut-out on the roller holder and
remove lock lever L. Pull out the lock lever shaft and remove the set buttons L/R,
lock lever springs L/R, and the interference board.
4. Turn hook C on lock lever R to the position of the cut-out on the roller holder and
remove lock lever R.
5. Remove the extension springs 0.4 from the left and right.
6. Pull the sub-roller bearings L/R out of the boss holes and remove them from the
release plates L/R.
7. Remove the sub-roller bearings L/R, tape hold bearings L/R, and tape hold shaft
from the sub-roller assy.
8. Remove the press roller springs L/R.
9. Remove the release plate rings. Remove the release plates L/R.
Hooks A
Side cover L
Release plate L
Press roller spring L
Boss hole
Release
plate ring
Set button L
Tape hold
Sub-roller
bearing L
bearing L
Tape hold shaft
Lock
Hook B
lever L
Cut-out
Lock lever
spring L
Lock lever
Extension
shaft
spring 0.4
Interference
board
Sub-roller assy
Tape hold bearing R
Sub-roller bearing
Fig. 3.7-4 Disassembling the Roller Holder Assy
3-22
Roller holder
Cut-out
Lock lever
spring R Set button
Extension
R
spring 0.4
Boss hole
Release plate R
Lock lever R
Hook C
Hook A
Side
cover R
Hook A
Press roller spring R
Release plate ring