Y-Diversion Lever; Reassembling The Y-Diversion Lever Assy - Brother LX-200 Service Manual

4.8 Y-diversion Lever

4.8.1 Reassembling the Y-diversion Lever Assy

1. Hold the Y-cutter guide shaft with the two rings at the right end. Insert the left end
into Y-cutter guide L and the right end into Y-cutter guide R.
2. Insert the Y-cutter guide shaft through the holes in the Y-diversion lever. Fasten with
the two Y-cutter guide shaft rings.
3. Stick new Y-diversion lever film on the Y-diversion lever, if it requires replacing.
Y-diversion lever
Y-cutter guide L
Y-cutter guide shaft
Fig. 4.8-1 Reassembling the Y-diversion Lever Assy
4-11
Y-cutter guide R
Y-cutter guide shaft rings
Y-diversion lever film