Definition Of Errors - Fujitsu FX-3001SR User Manual

7.1. Definition of Errors

An error message will be displayed when an error occurs while using this product.
Refer to the error messages and descriptions below and select the appropriate solution.
Some errors can be fixed while some are critical. When the description says "Contact
technical support", refer below for information on contacting our technical support.
Refer to 7.5 Technical Support (page 184)
Error Message
code
0001 RAM NG! 0xXXXXXXXX 0xXXXXXXXX
0xXXXXXXXX Error Code 0001
7
0002 ROM NG! 0xXXXXXXXX 0xXXXXXXXX
0xXXXXXXXX Error Code 0002
0003 System program Inflate NG! XXX
Error Code 0003
SERVIS IP-Serial
156
1p Converter
User's Guide
Detail
An error was detected when verifying SDRAM.
The first number is the error address (hexadecimal).
The second number is the written value
(hexadecimal).
The third number is the read value (hexadecimal).
Solution:
Check the SDRAM using the self-diagnostic
program.
Contact our technical support.
An error was detected when reading the flash ROM
twice.
The first number is the error address (hexadecimal).
The second number is the value that was read first
(hexadecimal).
The third number is the value that was read second
(hexadecimal).
Solution:
Check the flash ROM using the self-diagnostic
program.
Contact our technical support.
Failed to decompress the system program.
The number XXX is the error number (decimal).
100: Failed to secure heap buffer (1024 bytes of
work area for decompression could not be
secured)
101: Bad compressed file (bad magic header; the
first two bytes are not 0x1f, 0x8b)
102: Bad compressed file (bad magic header; the
third byte is not 0x8 or bits five to seven of
the fourth byte are not 0)
103: Bad compressed file (EOF detected)
104: Bad compressed file (bad CRC detected)
105: Bad compressed file (original size
anddecompressed size mismatch detected)
-2: Reached the end of the file being
decompressed
-3: Bad compressed file data
-4: Failed to secure memory for decompression
-5: No space in output buffer
Solution:
The system program is not stored on the flash ROM
correctly.
Contact our technical support.