Table of Contents
Advertisement
Example (from the local console)
The current serial port settings is displayed.
$ port
Enter↵
port name
baud
------------------------------------------------
Local port
115200 8 0 1 n 0x00 0x00
Target port
115200 8 0 1 n 0x00 0x00
$
Sets the target port with the settings of
baud rate: 115200 bps, bit length: 8, parity bit: none, stop bit: 1, flow
control: none.
$ port –t 115200 8 0 1 n
target port setting completed.
$
If the parameters are invalid, the following is displayed and the setting
changes fail.
$ port –t 115200
Enter↵
usage: port [-t|-l] [baudrate] [size] [parity] [stop] [flow] [xon] [xoff]
port [-r1|-r2|-wo|-rw] [port-number] | [-n]
$
When specifying parameter -n, the current TCP port number settings of the
Ether-direct connection and the status of current Ether-Direct connection
are displayed as shown below.
$ port –n
Enter↵
Ether-Direct
no.
------------------------------------------------
<read only1>
30000
<read only2>
30001
<write only>
30002
<read write>
30003
$
Sets the read-write port number for the Ether-direct connection to "30008".
$ port -rw 30008
Enter
$
d p s f xon xoff
Enter↵
status
-
-
-
-
SERVIS IP-Serial
71
1p Converter
User's Guide
4
Advertisement
Table of Contents
