7.3. Recovery (Returning to Factory Settings)
Perform a recovery procedure to return this product to initial settings.
Procedure
1.
Turn the power on while pressing the Init button. If this product is already on,
press the RESET button while pressing the Init button.
"...now system recovery..." is displayed as shown below and the device
switches to the recovery procedure.
While the LED lights in order of green, red, and orange, recovery is taking
place.
...now system recovery...
checking system memories...
................................RAM ok
................................ROM ok
......
7
....................................
2.
The message below is displayed, the LED blinks green, and recovery is
finished.
.......done!
***** Please turn off power, or reset. *****
3.
Restart the device. Make sure the status LED is blinking green, turn the power
switch off, and turn it back on, or press the RESET button.
The recovery procedure is finished. This product will start up with the initial settings.
The product takes approx. 2 minutes 15 seconds to start up immediately after
recovery is finished.
SERVIS IP-Serial
182
1p Converter
User's Guide