Setting The Target Port - Fujitsu FX-3001SR User Manual

2.8. Setting the Target Port

Configure the target port of this product according to the connected device.
2
The target port settings are configured using the port command in the shell console.
port command
Syntax
Refer to
The following explanation uses the target port settings below as an example:
Procedure
1. Execute the port command in the shell console.
$ port -t 115200 8 0 1 n
target port setting completed.
$
Once the port command is executed, changes to the port settings immediately take
effect.
This readies the target port for access.
To connect to the target port from a local console, refer to the following.
Refer to
For instructions on connecting from a remote terminal over a network, refer to the
following.
Refer to
SERVIS IP-Serial
22
1p Converter
User's Guide
port [-t | -l] [speed] [bit] [parity] [stop] [flow] [xon] [xoff]
4.1.17 port Command (page 70)
Protocol Value
Baud rate 115200 bps
Data length 8 bits
Parity None
Stop bit 1 bit
Flow control None
Enter
2.10 Controlling Target Devices via a Terminal Emulator (page 25)
2.9 Connecting from a Remote Terminal (page 23)
Default settings
9600 bps
8 bits
None
1 bit
None