Ff1 0 15, 16, And 17: Ssd Blocks - Panasonic DBS-576 Technical Manual

Section 400-Programming
Introduction

FF1 0 15, 16, and 17: SSD Blocks

NOTE: Use these addresses to set up groups or "blocks" of SSD numbers,
0 and assign them to MCO Tenant Groups. You can also set up an "SSD
System
common block" that can be used by all extensions.
Configuration
FF1
SSD Block Assignment to MCO Tenant Groups
System
(all CPCs) - Version 1.0 or higher
Assign System Speed Dial (SSD) blocks to MCO Tenant Groups. Extensions that
belong to an MCO Tenant Group can use the SSD codes within the assigned SSD block.
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
NOTE: Available range for MCO Tenant Groups depends on system size:
FF5
Groups
FF6
TRS/ARS
Notes:
FF7
Applications
Related Programming:
SSD Assignment to Groups (pg. 1-23)
FF8
Extension COS: SSD Dialing (pg. 1-45)
Maintenance
SSD Common Block for MCO Tenant Groups (pg. 1-100)
SSD Block Assignment (pg. 1-100)
Tenant Group MCO Access: Outbound Trunk Groups (pg. 1-164)
Hold
Appendix A
Appendix B
576-13-400
FF1 0 15 (0001-0072) Hold (0-72) Hold
Address No. for MCO Tenant Group:
0001=MCO Tenant Group #1
0002=MCO Tenant Group #2
...
0072=MCO Tenant Group #72
in a 96-port system:
in a 192-port system:
in a 288-port system:
in a 384-port system:
in a 480-port system:
in a 576-port system:
FF1 0 17 (0001-0144) Hold (0-799 or 0-800) Hold
DBS 576 (USA) issued 05/20/98
0=no SSD Block assignment (can use
SSDs in common block only)
1=SSD Block #1 (default)
2=SSD Block #2
3=SSD Block #3
...
72=SSD Block #72
Groups 1-12 (0001-0012)
Groups 1-24 (0001-0024)
Groups 1-36 (0001-0036)
Groups 1-48 (0001-0048)
Groups 1-60 (0001-0060)
Groups 1-72 (0001-0072)
FF1 0 02 0003 Hold (0 or 1) Hold
FF1 0 03 (00-15) 11 Hold (0 or 1) Hold
FF1 0 16 0001 Hold (0-800) Hold
FF1: System Programming
%  753
FF1 3 01 (0001-0360) Hold (0-99 or 0-72)
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 1-99