Panasonic DBS-576 Technical Manual page 256

FF2: Trunk Programming (Analog CO)
Introduction
Trunk Signal Type
(all CPCs) - Version 1.0 or higher
Set the analog CO trunk's signaling type.
0
System
Configuration
BSSC: Analog (CO) Trunk Position
FF1
B=Cabinet no. 1-6
System
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2
Notes:
Trunks
Related Programming:
FF3
Extensions
FF4
Loop Detect
FF-/Soft Keys
(all CPCs) - Version 1.0 or higher
("fire-and-disconnect") Enable/Disable system check for Loop Detect, if the
trunk is set for Loop-Start signaling in Trunk Signal Type (previous address).
FF5
Groups
FF6
TRS/ARS
FF7
Notes:
Applications
If this address is set to "1" (Loop Detect enabled), system will check for loop signal when the trunk is
seized to place an outgoing call.
FF8
Related Programming:
Maintenance
Trunk Signal Type (pg. 2-8)
Appendix A
Appendix B
Page 2-8
FF2 0 BSSC 01 00 Hold (0-3) Hold
FF2 0 BSSC
BSSC: Analog (CO) Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2 0 BSSC 01 00 Hold (0-3) Hold
DBS 576 (USA) issued 05/20/98
0=Loop Start (default for LS and LS/GS card)
1=Ground Start (default for GS card)
2=DID Immediate Start (default for DID card)
3=DID Wink Start
01 01 Hold (0 or 1) Hold
0=No Loop Detect
1=Loop Detect (default)
Section 400-Programming
$
, %6
$
5!!6 '
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B