Dial Tone Detection - Panasonic DBS-576 Technical Manual

FF2: Trunk Programming (Analog CO)
Introduction
Flash Pattern
(all CPCs) - Version 1.0 or higher
Set which pattern will be used for flash signals to the CO on this trunk.
0
(see System Timers to define Flash Patterns #1 and #2)
System
Configuration
FF1
System
FF2
Trunks
Notes:
Two different Flash Patterns can be defined in Flash Timers 1 and 2, FF1 1 01 (0001-0002).
FF3
Related Programming:
Extensions
Flash Timer 1 for Trunk Line (pg. 1-115)
Flash Timer 2 for Trunk Line (pg. 1-116)
FF4
FF-/Soft Keys

Dial Tone Detection

(all CPCs) - Version 1.0 or higher
FF5
Set whether the system will check for CO dial tone before sending dialed digits
Groups
on this trunk.
FF6
TRS/ARS
BSSC: Analog (CO) Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
FF7
C=Circuit no. 1-8
Applications
Notes:
FF8
Maintenance
Related Programming:
Appendix A
Appendix B
Page 2-18
FF2 0 BSSC
BSSC: Analog (CO) Trunk Position
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-8
FF2 0 BSSC
DBS 576 (USA) issued 05/20/98
02 01 Hold (0 or 1) Hold
0=Flash Pattern #1 (default)
1=Flash Pattern #2
FF1 1 01 0001 Hold (1-255) Hold
FF1 1 01 0002 Hold (1-255) Hold
02 02 Hold (0 or 1) Hold
0=No check (use precoded delay timer).
1=Check (send digits after dial tone is
detected). (default)
Section 400-Programming
$
",9 59
$
% '
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B