Panasonic DBS-576 Technical Manual page 288

FF2: Trunk Programming (Analog E&M Tie)
Introduction
Balance Control
(all CPCs) - Version 1.0 or higher
For impedance matching in balanced networks. Controls sidetone level on
0
the trunk, based on the distance between the phone system and the other end.
System
Configuration
FF1
BSSC: E&M Tie Trunk Position
System
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
FF2
Trunks
Notes:
Because there are so many factors involved in choosing Long Loop or Short Loop (such as what kind
of wire/match is used for each connection; distance; Ohms/match; R, L, & C; etc.), this setting should be
FF3
tested on the trunk, or changed only if problems occur.
Extensions
Related Programming:
FF4
FF-/Soft Keys
Pad Control
FF5
(all CPCs) - Version 1.0 or higher
Groups
For balanced networks. Controls voice level on the E&M tie trunk, depending on
the distance between the phone system and the other end (CO or another system).
FF6
TRS/ARS
BSSC: E&M Tie Trunk Position
FF7
Applications
Notes:
FF8
Maintenance
Related Programming:
Appendix A
Appendix B
Page 2-40
FF2 0 BSSC
FF2 0 BSSC
B=Cabinet no. 1-6
SS=Slot no. 01-12
C=Circuit no. 1-4
DBS 576 (USA) issued 05/20/98
01 07 Hold (0 or 1) Hold
0=Long Loop (default)
1=Short Loop
01 08 Hold (0 or 1) Hold
0=Far (default)
1=Near
Section 400-Programming
$ %
7,' !!,
$ 
$/ !!,
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B