Panasonic DBS-576 Technical Manual page 184

FF1: System Programming
Introduction
Start Timer for CO Busy Tone Detect
(Auto-Repeat Dial)
(all CPCs) - Version 1.0 or higher
0
System
Set the length of time the system will wait after the last auto-dialed digit is sent to
Configuration
the CO (on an analog trunk) during an Auto-Repeat Dial, before starting the
CO Busy Tone Detect Timer (Auto-Repeat Dial) (see next address). This allows
time for the CO to connect the call before the system starts looking for busy tone.
FF1
System
FF2
Trunks
FF3
Extensions
Notes:
Auto Repeat Dialing: Place a call to a busy party. Stay in monitor mode and press REDIAL. System
automatically redials the number, and repeats redialing until ringback is heard or 14 auto-repeat
FF4
attempts have been made.
FF-/Soft Keys
Related Programming:
FF5
Flash Timer for Auto-Repeat Dial (pg. 1-117)
CO Busy Tone Detect Timer (Auto-Repeat Dial) (pg. 1-123)
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B
Page 1-122
FF1 1 01 0014 Hold (1-255) Hold
DBS 576 (USA) issued 05/20/98
1=1 second
2=2 seconds
...
255=255 seconds (or 4 min./15 sec.)
default: 5 seconds
FF1 1 01 0003 Hold (1-255) Hold
FF1 1 01 0015 Hold (1-255) Hold
Section 400-Programming

/ 7% 
576-13-400
Introduction
0
System
Configuration
FF1
System
FF2
Trunks
FF3
Extensions
FF4
FF-/Soft Keys
FF5
Groups
FF6
TRS/ARS
FF7
Applications
FF8
Maintenance
Appendix A
Appendix B